Tape Hanger/Holder (Parametric)

Parametric hanger for your rolls of tape, designed to be stucked on the vertical surface with 25mm double-sided tape.No support, prints on the side. You can adjust the parameters in Fusion to generate a hanger for your specific needs, parameters are:TapeWidth - the width of the roll of the tame, as measuredTapeWidthClearance - clearance added to the width, 2mm by defaultRollDiameter - the inner diameter of the roll, for big rolls it's usually 75mmLipSize - the size of the lip, that does not allow the roll to slip of the hanger, 5mm by defaultScotchWidth - width of the double-sided tape used to stick the hanger to the wall, by defalt 25mmThe models for the sizes I found around my house are available: (TapeWidth x RollDiameter)50x75 - the most common wide roll of tape25x75 - also very common narrower size24x75 - some rolls of foamy double sided tape are 24mm in width, but you can use 25x75 model instead19x40 - electrical tape19x32 - electrical tape9x75 - Kapton tapeEmbossed size on t