MakerWorld
Organizers
Go to Model
Tape holder pegboard/wall
49
Downloads
18
Likes
38
Makes
Tape holder for mounting on Biltema pegboard (cc12mm) or on wall All models is designed too use orginal short skrew from Biltema, and no need for print support 4 versions, 5 print profile where main is with all 4 sizes Small short:Ø20 with Ø25 lip25 mm deep2 mounting holes Small long:Ø20 with Ø25 lip 50 mm deep2 mounting holesextra support under half sylinder Big short:Ø45 with Ø50 lip35 mm deep3 mounting holes Big long:Ø45 with Ø50 lip55 mm deep3 mounting holesextra support under half sylinder I have printed this in Bambu PLA Tough+ Boost MeIf you enjoy my designs, you can support my work with a boost :)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
