Thingiverse
Tape Holder (table/wall mount)
von rconfx
131
Downloads
71
Likes
4
Makes
Made a tape holder with the aim of mounting it to the Ikea "Lack" table. It can be used together with every table, or even as a wall mount.
It is made rolls with a maximum width of approx. 52mm. The "bow" fits perfect for a roll with a Diameter of 75mm (or bigger). The minimum (!) diameter of the roll you can use with this holder is 61mm to press the roll onto it (without using the bow).
The hole is for a M3.5 screw but can be drilled up to M4 (or maybe even bigger).
It is made rolls with a maximum width of approx. 52mm. The "bow" fits perfect for a roll with a Diameter of 75mm (or bigger). The minimum (!) diameter of the roll you can use with this holder is 61mm to press the roll onto it (without using the bow).
The hole is for a M3.5 screw but can be drilled up to M4 (or maybe even bigger).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
