Thingiverse
Tape Measure Mount
by PrintMills
38
Downloads
20
Likes
2
Makes
Simple Tape measure mount to screw to the cabinet or wall.
Counter sunk # 6 screw holes.
Spent way to much time with the caliper at Home Depot determining the average width and height of the center section. Should work with almost every clip style tape measure on the market.
My first upload.
Kinda a no-brain'r but.... print facing down like in the image to avoid supports.
3 layers on the outer....Also did this with a 60% infill in a gyroid pattern even though that's pry overkill.
6 months later and still holding up great in PLA+
Counter sunk # 6 screw holes.
Spent way to much time with the caliper at Home Depot determining the average width and height of the center section. Should work with almost every clip style tape measure on the market.
My first upload.
Kinda a no-brain'r but.... print facing down like in the image to avoid supports.
3 layers on the outer....Also did this with a 60% infill in a gyroid pattern even though that's pry overkill.
6 months later and still holding up great in PLA+
PrintMills also publishes on
10 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
