Tapo C110 Camera mount

This Tapo C110 camera mount is a remix of the model found here: https://makerworld.com/en/models/83120-magnetic-camera-mount-for-tp-link-tapo-c110?from=email_notification#profileId-88665 Thanks for the design @user_3524734546 soerenharaldsson I used the design, and put a 30 degree angle on it, so that it can see much lower in the printer I am using it on - the Creality K2 Plus I recommend printing in black to prevent reflections, and depending on how hot your printer gets, it could be worth doing this in ABS or similar more heat resistant material. No supports are needed - put the flat parts of the prints on the print bed. You might wonder how to fit the camera, with the stick out the bottom. The stick on the camera can be removed, there is a small rubber bung in the end, with a screw underneath. Unfortunately two of the very bottom corners are slightly in the cameras view. If I were to try and fix that I would probably put it back to a 25 degree angle - I will update if I do make this