Thingiverse
tapo C200 Wall Mount
von Rinus123
0
Downloads
1
Likes
0
Makes
Designed up this camera stand (wall mount) for a safe use around any desired room
Printing:
Infill at 20% and supports everywhere needed for raised tabs on the base.
Bed Temp 60 degree Celcius
Nozzle 210 degree Celcius
Printing:
Infill at 20% and supports everywhere needed for raised tabs on the base.
Bed Temp 60 degree Celcius
Nozzle 210 degree Celcius
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
