Tapo Camera stand

Tapo 360 camera mount (or any camera that shall fit on the 70mm base), or adjust it to your preferred size. This was made to a height of 240mm, to account for the A1 I printed it for being raised on a concrete slab, and I wanted a downward angle within the cameras ability.I used marble PLA for the print in the attached images, it seems the PLA I used may have been a little ‘wet’ , but otherwise it seems to print fine. It would print more quickly and without supports if the trunk was square and set it the back, but I find the balance is off that way, and I prefer the look of it like this personally. Make it your own and I hope you get some use from it. 👍🙂Boost MePlease consider Boosting me if this design was useful to you, thank you.