Thingiverse
Tapping Wrench
door Lote_VR
46
Downloads
33
Likes
0
Makes
This Item was printed in:REAL-Filament's Natural (Clear) PLA ø1.75.
Slicer: Slic3r Prusa Edition
I had a tapping bit that did not fit the current tapping wrench I have so i made one to allow me use the bit.
Print Settings
Quality
Layer height: 0.20mm
Shell
Perimeters: 7
Solid top layers: 7
Solid Bottom layers: 7
Infill
Infill Density: 30%
Infill Pattern: Honeycomb.
Infill Overlap Percentage: 20%
Skin Overlap Percentage: 20%
Speed
Print Speed: 70 mm/s.
Travel Speed: 120 mm/s.
Support
Enable Support: No.
Build plate Adhesion
Build plate adhesion type: Brim.
Brim Width: 6mm.
Slicer: Slic3r Prusa Edition
I had a tapping bit that did not fit the current tapping wrench I have so i made one to allow me use the bit.
Print Settings
Quality
Layer height: 0.20mm
Shell
Perimeters: 7
Solid top layers: 7
Solid Bottom layers: 7
Infill
Infill Density: 30%
Infill Pattern: Honeycomb.
Infill Overlap Percentage: 20%
Skin Overlap Percentage: 20%
Speed
Print Speed: 70 mm/s.
Travel Speed: 120 mm/s.
Support
Enable Support: No.
Build plate Adhesion
Build plate adhesion type: Brim.
Brim Width: 6mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!