Tapuino Case (Commodore 64)

This is a 'clip together' case for the Tapuino board obtained from
www.cbmretro.fi
It gives you
- top access to the switches rather than the rear and
- leaves full access to the SD card.

I did not craft the logo from scratch, but used the one created by svenpetersen1965 at https://www.thingiverse.com/thing:3915453, removed the base and scaled it.

**Print orientation** is important especially for the bottom, otherwise you may end up breaking the switches or clips when removing supports. Make your supports as sparse as possible. You don't want supports messing with the clip slots either!

**Tapuino bottom**
Should be oriented with the switches on the base with the long side vertical. Switches from left to right are "Next", "Previous", "Back", "Select/Play"
The photo shows an error in the button offsets, this has been corrected.

**Tapuino top**
Orient with the C= Logo on the bottom, again standing tall

Note:
- I am **not** affiliated with cbmretro.fi
- OpenSCAD