Thingiverse
Taranis Clearview Receiver Mount
by hattybin
9
Downloads
8
Likes
0
Makes
This olds a clearview on the back of a taranis, inside the bar. There is an SMA hole so you can run some coax to extend the lower antenna to it so both antennas are on top.
Print in TPU or other flex material because the slots for the bars have to give so the hold the mount on tight.
Print in TPU or other flex material because the slots for the bars have to give so the hold the mount on tight.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
