Thingiverse
Taranis X9D+ Power Switch
by fpvga
15
Downloads
10
Likes
0
Makes
Plastic piece of the power switch for the Taranis X9D+ SE. I just found the stock power switch super chintzy feeling, and I hate the glossy plastic. So I made a new one.
You need to open up the case, remove the power switch module, and replace the plastic switch. It should fit as is, though it appears there are a few different length switches. If it doesn't fit without creating too much pressure, you can just snip off 1-2mm from the switch itself so it fits better into the indentation in this part.
The Fusion360 source project is at http://a360.co/2BYrSjm
You need to open up the case, remove the power switch module, and replace the plastic switch. It should fit as is, though it appears there are a few different length switches. If it doesn't fit without creating too much pressure, you can just snip off 1-2mm from the switch itself so it fits better into the indentation in this part.
The Fusion360 source project is at http://a360.co/2BYrSjm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
