Tarantula Rear Tower Support

The main problem with the Tevo Tarantula series is that it is based on the infamous single frame design of prusa i3 variant which most of them has an issue of swaying to the rear or at least where the weight is.

Tarantula's weight are more towards the back and as a result, a high skew angle were produced and it is noticeable; skew angle at 1.423 degree off of a 20 x 20 x 100mm cube

This part here is to support the tower of the frame by pushing forward to make it very close to 90 degree as much as possible for the z axis (between y min and y max)

The "top long.stl" if you're going to use the stock acrylic motor mount but still wanted to use this rear tower support, I made this so that the acrylic are also supported by the rear support