Thingiverse
Tardis USB Case!
por ebat
47
Descargas
38
Likes
0
Makes
A tardis shaped USB Case!
Fits a usb up to 1.3" in length, with 0.5" of the plug can stick out.
The USB should be an interference fit, but the edges of the hole may require a small amount of sanding.
I drilled a small hole in both side and glued a small pin in the bottom to keep the USB plug from getting bent in case a triple point bend is applied to it.
Fits a usb up to 1.3" in length, with 0.5" of the plug can stick out.
The USB should be an interference fit, but the edges of the hole may require a small amount of sanding.
I drilled a small hole in both side and glued a small pin in the bottom to keep the USB plug from getting bent in case a triple point bend is applied to it.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
