Thingiverse
Targus Docking Station Wall Mount
di DoubleKlutch
0
Download
1
Likes
0
Makes
I made this mounting bracket for a family member who works from home. They have a laptop in the center of two screens, and with no where really safe, easy or convenient to put the docking station, they asked me to find a way to mount it behind one of the monitors. I opened Fusion 360 and came up with this.
It is 5" x 1" x 0.25".
Printed with an Ender 3 S-1 using Inland Black PLA+ 1.75mm.
Initial Nozzle Temp of 205.0 and Bed Temp of 65.0 and 200.0/60.0 for the rest of the print.
20% Infill, Layer Height of 0.2mm
Minimal supports to support the brim in the docking station holes to keep them from stringing.
Make sure you rotate the model 90* to make sure it lays flat.
It took just over 1h 10m to print. Zero finishing required, except for removing the support if you chose to use them.
It is 5" x 1" x 0.25".
Printed with an Ender 3 S-1 using Inland Black PLA+ 1.75mm.
Initial Nozzle Temp of 205.0 and Bed Temp of 65.0 and 200.0/60.0 for the rest of the print.
20% Infill, Layer Height of 0.2mm
Minimal supports to support the brim in the docking station holes to keep them from stringing.
Make sure you rotate the model 90* to make sure it lays flat.
It took just over 1h 10m to print. Zero finishing required, except for removing the support if you chose to use them.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
