Thingiverse
Taurus SHO Trunk Release Lever
door shoengine
0
Downloads
0
Likes
0
Makes
Trunk release lever for the driver side of the first generation Taurus SHO. Probably works on any other Ford of that vintage that also has the trunk and fuel door release levers between the driver side door sill and seat.
The fit can be a little tight. I used a small hammer and a punch to seat mine, however you could feasibly increase the size by 1 or 2% to get a little more play if necessary.
I suggest printing with the blade opening on the build plate (so the lever is vertical) and with support. The support easily peels off the majority of the part, and the little bit inside the blade opening also comes out easily.
The fit can be a little tight. I used a small hammer and a punch to seat mine, however you could feasibly increase the size by 1 or 2% to get a little more play if necessary.
I suggest printing with the blade opening on the build plate (so the lever is vertical) and with support. The support easily peels off the majority of the part, and the little bit inside the blade opening also comes out easily.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
