TAZ 5 1.75mm Conversion Using e3d v6

1.75mm extruder conversion for LulzBot Taz 5 using generic e3dv6 hotend parts.

You will need the following to assemble the hotend
* A generic e3d v6 hotend. Clones are available online for around $20, but make sure to get one with a 24v heater cartridge
* Two M3x20 bolts, two M3x10 bolts, and four M3 nuts (for DaVinci2000's part cooler shroud)
* A 5015 "squirrel cage" blower fan (for the part cooler)
* Some short wires, about 22AWG
* Pin headers
* a 4-pin header for the stepper, a 2-pin header for the part cooler fan, and a 2x8 header for the TAZ hotend connector - I used two smaller headers side-by-side, a 2x3 for the thermistor and a 2x5 for everything else
* The old hotend/extruder from your TAZ 5
* A generic bowden extruder
* Some bowden tube (58mm long)