Taz4/5 Silicone Bed Leveling System

This modification is one more step in cleaning up layer offset artifacts (z wobble).

This takes the original design and adds a round extension to better support a silicone bed leveling spacer that replaces the spring. It also adds a spacer under the bed plate to increase the support from below.

Parts:
I used these silicone columns with a 35mm M4 bolt.
https://www.amazon.com/dp/B0BK3L3T8S

These should also work but are higher than needed and will require a much longer M4 bolt.
https://www.amazon.com/dp/B07S2R5C6P

(8) M3 Socket Head Screws (you can reuse the ones that originally in similar position, but they no longer will thread through the bed plate)
(8) M3 Short Heat Insert Nuts (insert into the corner base)
(4) M4 x 35mm Socket Head Screws (or alternatively 45mm length with a taller silicone column)
(4) M4 Long Heat Insert Nuts (insert into adjustment knob)

With the shorter silicone columns, there should be no need to extend the Z stop adjustment screw. If you