Thingiverse
TBS Crossfire Micro TX Module wedge
von JamesKomodo
6
Downloads
0
Likes
0
Makes
A simple little wedge to stop your TBS Crossfire external transmitter module from falling out mid flight. Takes less than 5 minutes to print but could save your drone.
Recommended to print in a flexible filament.
I have printed this in PLAFlex and it fits perfectly for my module on my Jumper T16.
Some versions of the module/T16 are slightly wrong and they don't click together properly, in which case the tabs might be closer together. Resize accordingly. My unit already clicks into place, so this is just extra "insurance" for me.
Leave a comment if you appreciate this design :) P.S extra points if someone tells Joshua Bardwell about this.
Recommended to print in a flexible filament.
I have printed this in PLAFlex and it fits perfectly for my module on my Jumper T16.
Some versions of the module/T16 are slightly wrong and they don't click together properly, in which case the tabs might be closer together. Resize accordingly. My unit already clicks into place, so this is just extra "insurance" for me.
Leave a comment if you appreciate this design :) P.S extra points if someone tells Joshua Bardwell about this.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!