Thingiverse
TBS Mambo flat stand for modules
by IB-King
3
Downloads
5
Likes
0
Makes
This is super hard to put on. You will most likely need to take the kick stand off of your Mambo . Then turn the printed stand piece sideways and shove that sucker onto the kickstand leg. it was SUPER HARD for me. Then turn it back into the vertical orientation. Rinse and repeat, all set.
I've included a looser version, but I prefer the tighter one. even though it is SUPER HARD TO SLIDE ON.
Also PRINT IN TPU as there will be no way to install if it is a rigid material !!!
I think this would make great finger grips for large handed thumbers.
I've included a looser version, but I prefer the tighter one. even though it is SUPER HARD TO SLIDE ON.
Also PRINT IN TPU as there will be no way to install if it is a rigid material !!!
I think this would make great finger grips for large handed thumbers.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
