TBS Race Tracker Mod case

This is a modified case to replace the stock Case for the TBS race tracker. I wanted to make this case so i could move the antenna to the outside for better a better connection. I was also having problems with my unit freezing up and i had to let the battery die before it would shut down, so i added a switch to solve this problem.

Additional items needed

m3 bolts
mini latching push button switch
roughly 2 inch wire 12-14 guage i believe.

https://www.amazon.com/gp/product/B075VBV4QH/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

Assembly:

1) Remove the electronics from the original case.
2) De-solder the hot wire from the board.
3) Solder roughly 2 inch wire to the board in place of the original hot lead from the battery and leave the other end open for now.
4) Cut the shrink wrap from around antenna and remove,
5) Run antenna lead through top 3d printed plate through the second hole from the top right and then through original bolt hole on the upper right side of bo