Slicer Discord
TBS SOURCE MICRO ANTENNA MOUNT AND BACKPANTS! – 3D-Druckmodell von Thingiverse Thingiverse

TBS SOURCE MICRO ANTENNA MOUNT AND BACKPANTS!

3 Downloads
1 Likes
0 Makes
Zum Modell
If your source micro is anything like my guy is then your aware of the the ole 10 pounds of shit in a five pound bucket saying. I wanted something clean and that held up that new TBS Pro antenna with the mmmxxxxxcxxx connector. I'm flying xt60 because I have yet to give a bums poop about getting xt30 batteries. The two holes up and down are for straws so you can put your tbs crossfire antenna in there. and hot glue them in there with a little shrink wrap on the ends. Don't use paper straws ya hippies they don't do well in the rain and they catch on fire. I thought about putting an immortal t on the thing and well it's kinda silly when people are getting range with the antennas from the kit. and the immortal t weight. That would be cool to have a micro immortal T. IBCrazy get on it. I have to think about that on a 2.5 inch that might do long range. there is a little storage back there and it is easy to wire no holes and everything should stick out the old top. I have more pics that I'
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen