Thingiverse
TBS Source One V5_xt60 mount
by lennard1x
2
Downloads
2
Likes
0
Makes
hello,
I designed this xt60 mount for the TBS Source One V5 frame. To install it, you have to take off the grey protection from the xt60 connector and solder the cables at an angle from almost 90 degrees.
Because the missing grey protection from the xt60 connector, you can use hot glue or something similar to protect the connection and prevent it from short circuit.
I would be happy, if you share your results here and upload some pictures from your built.
I designed this xt60 mount for the TBS Source One V5 frame. To install it, you have to take off the grey protection from the xt60 connector and solder the cables at an angle from almost 90 degrees.
Because the missing grey protection from the xt60 connector, you can use hot glue or something similar to protect the connection and prevent it from short circuit.
I would be happy, if you share your results here and upload some pictures from your built.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
