Thingiverse
TBS Source One XT60 + SMA Mount
von IrrerPolterer
20
Downloads
14
Likes
0
Makes
This model is inspired by [this entry](https://www.thingiverse.com/thing:4741250), but modified to fit the 5-Inch version of the *TBS Source One* frame. It is also a bit easier to print, because I reduced the angle of overhangs.
There are different versions of this mount for the *5-Inch* and the *3-Inch* version of the TBS Source One frame. Please make sure to print the correct size for your quadcopter!
The 3MF-files include PrusaSlicer printing settings for TPU filament.
There are also STEP-files to make remixing easier. The simplified STEP files can be more easily edited than the final versions, which include a lot of fillets.
*Side Note: If you're interested in the ELRS antenna holder that's shown on the pictures, check out [this design](https://www.printables.com/model/163319).*
There are different versions of this mount for the *5-Inch* and the *3-Inch* version of the TBS Source One frame. Please make sure to print the correct size for your quadcopter!
The 3MF-files include PrusaSlicer printing settings for TPU filament.
There are also STEP-files to make remixing easier. The simplified STEP files can be more easily edited than the final versions, which include a lot of fillets.
*Side Note: If you're interested in the ELRS antenna holder that's shown on the pictures, check out [this design](https://www.printables.com/model/163319).*
IrrerPolterer veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
