TBS Unify Holder

This is a simple mount for a TBS unify. It provides space underneath to locate and mount your receiver underneath and then allows for the TBS VTX to be mounted on top. Its printed in two part to make it easier to print and also allows for some adjustment to fit in the frames. This was made specifically for the Armattan Chameleon, but would fit most other long deck frames. Overall height is 15.5mm.

For the Chameleon I used a hacksaw to cut the tabs on the Unify pigtail to it fitted into the rear VTX mount.

Once you are have the top and bottom located how you want just use some superglue to glue together. This will also strengthen the whole piece.

There are also ziptie slot to allow you to ziptie to the frame and also the TBS pigtail to reduce any stress on the UFL. All I did was turn the UFL connection 180 degrees to fit nicely in the Chameleon frame. (Refer pictures for details)

This is a functional design, and is not the prettiest, but so far has worked well. I have not