Tea Infuser Lid

The original tea pot did only come with the infuser.

So I set out to design a lid that:
> fitted as snug as possible
> stays put when pouring tea
> keeps vapor/condens in
> is water/vapor tight
> withstands 100 degrees Celsius

That last one was solved accidentally: I set up a new spool from the dry-box without checking the label..I never saw PETG warp so incredibly...it appeared to be PolyCarbonate...duh

The other demands were met after a few trials.

The knob and lid are printed separately and should fit snugly.

Screw/unscrew a few times to remove any burrs or oozing artifacts.