Slicer Discord
Teal Drone Float – Modelo 3D imprimible de Thingiverse Thingiverse

Teal Drone Float

por TuckyIA
0 Descargas
2 Likes
0 Makes
Ver Modelo
Here is a float for your Teal drone.
Picture this: You are flying over a lake. Suddenly, your battery cuts out and the drone falls from the air into the deepest part of the lake. Normally, it would be R.I.P drone, but with this, it will float on the surface with a good chance of being repaired if the battery doesn't have any charge left to be short-circuited. Tada, you either saved tons of time contacting Teal about a warranty or spending hundreds more to buy a new drone. Also, this will protect the lake, too, as it won't get stuck with what is likely a non-biodegradable drone stuck at the bottom.
Not for use when there are large waves.
I claim no responsibility if something goes wrong and you cannot rescue the drone.
It is highly recommended that you use a better print quality printer than I did.
Have fun and fly on!
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección