Team Corally Steering Bellcrank

This part broke after the car hit against an obstacle. Disgned this quick'n'dirty and will use it until the next order. The original spare parts costs just a few bucks. Replaces one part in this set: C-00180-036
I removed the stairs effect from the 0.2 layers with sand paper. Maybe it's a good idea to try 0.1 layer next time.

UPDATE:
One hard crash later, I had print another one in 0.1 and I definitely recommend this. Took me at 60 mm/s around 75 minutes to print.

UPDATE 2:
After another crash, I reinforced it ab bit and printed in ABS.

UPDATE 3:
Pritning in ABS did not make any difference, it brakes at the same spot. So created Version 2 to be more robust and back to PLA.

UPDATE 4:
If Version 2 does not fit in your steering setup, try Version 3. :D

UPDATE 5:
Added Version 4.