Tear Drop Shift Knob

### Modeled after the NSX-R, Type-S shift knob.


## Variations
There are several variations on this model:

* standard - replica of the original shift knob
* standard, countersunk - sits approximately 20mm lower
* shortened - The stem was reduced by about 25mm

Threads are modeled for Honda/Acura thread pattern of 10Mx1.5. Make sure your printer is dialed in well and print at 0.10 - 0.15mm heights for it to screw on correctly. Check if your printer is calibrated correctly by printing this screw thread calibration test: https://www.thingiverse.com/thing:5617268

## Weight
The shift knob is hollow and you can add pellets to increase weight. I was able to add lead bb's and achieved 300g. I also found that the shortened shift knob didn't seem to benefit much from adding weight because it sits close to the top of the shift lever. I think the standard height version would benefit most from adding more weight since it sits about 3" higher.

## Print settings
* Walls 3
* I