Thingiverse
Technic Compatible Wall Mount (4-6mm Screw)
por Fourdee4D
0
Descargas
0
Likes
0
Makes
This is my take on a Technic compatible wall mount. It allows for a maximum of 6mm screw.
The screw hole is also countersunk.
I personally use 6mm compatible wall plugs and screws. However, 4mm should also be fine.
For PLA+:
- 25% infil should be enough for small/Medium models.
- For larger models (eg: £200 in value), use 45% or higher.
The screw hole is also countersunk.
I personally use 6mm compatible wall plugs and screws. However, 4mm should also be fine.
For PLA+:
- 25% infil should be enough for small/Medium models.
- For larger models (eg: £200 in value), use 45% or higher.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
