Thingiverse
Technic rim old school 43mm
door MadScientist77
0
Downloads
1
Likes
0
Makes
This is a dimensionally accurate technic 43mm x 24mm rim from back in the day.
Both ABS and PLA/PLA+ work well. Suggest very fine layer height (0.06 - 0.12mm).
Sounds crazy, but setting a 2.4mm wall thickness will negate the need for infill,
and produce a nice solid part.
Gently hand drilling with a 3mm drill bit through the centre of the axle cross will allow axles to push in more easily.
I had the most success printing "six holes" side up, running concentric support at 20%, or 1mm line gap.
This is not a 3D scan. I have created this in CAD after much measuring!
Have fun, and let me know what you think!
Both ABS and PLA/PLA+ work well. Suggest very fine layer height (0.06 - 0.12mm).
Sounds crazy, but setting a 2.4mm wall thickness will negate the need for infill,
and produce a nice solid part.
Gently hand drilling with a 3mm drill bit through the centre of the axle cross will allow axles to push in more easily.
I had the most success printing "six holes" side up, running concentric support at 20%, or 1mm line gap.
This is not a 3D scan. I have created this in CAD after much measuring!
Have fun, and let me know what you think!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!