Thingiverse
Technoblade Memorial Repaired for FDM
par DradisPrints
6
Téléchargements
7
Likes
0
Makes
Fixed DJScope's version to make it printable on my FDM. Prints at 3 1/2 inches tall or higher. Supports must be used! My daughter is a huge fan of Technoblade and I fixed this so I could print it for her. I make my fixed verson available for the rest of his fans here.
My Fixes (verified at 3 ½ inches or 8.9 cm tall):
-Minimum thicknesses of parts set to 1mm.
-Scaled to 3 ½ inches tall or 8.9 cm
-Repaired mesh errors.
-Reduced detail to make printable.
My tested print settings (took 5hrs):
-.2mm to .32mm variable layer height (the base at .32).
-Painted on supports for 35-degree parts.
-Printed at 3 ½ inches tall.
-10% support cubic infill.
-Perimeters set to 2.
-Printed with Overture PLA.
I recommend if you are not conformable using painted supports or variable layer heights, use .2mm and supports everywhere. I also recommend you set the support overhang threshold to 45-degrees because the back angle of the cape can be tricky if your ad
My Fixes (verified at 3 ½ inches or 8.9 cm tall):
-Minimum thicknesses of parts set to 1mm.
-Scaled to 3 ½ inches tall or 8.9 cm
-Repaired mesh errors.
-Reduced detail to make printable.
My tested print settings (took 5hrs):
-.2mm to .32mm variable layer height (the base at .32).
-Painted on supports for 35-degree parts.
-Printed at 3 ½ inches tall.
-10% support cubic infill.
-Perimeters set to 2.
-Printed with Overture PLA.
I recommend if you are not conformable using painted supports or variable layer heights, use .2mm and supports everywhere. I also recommend you set the support overhang threshold to 45-degrees because the back angle of the cape can be tricky if your ad
DradisPrints publie également sur
14 modèles supplémentaires sur 2 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
