Thingiverse
TechOne DLG-1000 repairs
by dan1d
1
Downloads
1
Likes
1
Makes
Various parts for repairing my DLG-1000. may or may not be useful to others.
During a bad crash, my wing pulled apart a bit at the reinforcement near the fuselage. I removed the foam around the reinforcement and made a "brace" thing to glue to the reinforcement. The reinforcement I refer to is covered by strong tape, but is an embedded plastic "T" structure that glues together each wing side.
The boom broke just aft of the horizontal stabilizer. The splint piece here should be printed horizontally so it is stronger in the "bending" axis.
During a bad crash, my wing pulled apart a bit at the reinforcement near the fuselage. I removed the foam around the reinforcement and made a "brace" thing to glue to the reinforcement. The reinforcement I refer to is covered by strong tape, but is an embedded plastic "T" structure that glues together each wing side.
The boom broke just aft of the horizontal stabilizer. The splint piece here should be printed horizontally so it is stronger in the "bending" axis.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
