Thingiverse
Teddy bear night light
von Nina1982
7
Downloads
6
Likes
0
Makes
I designed this night light for my daughter. It is a representation of her favorite teddy bear. It can be opened and closed, these parts fit perfectly in each other. I added a (usb) rechargeable light (bicycle light or headlight) which is attached to the back with a poster buddy. The colored elements are glued onto the front part with super glue. The printed version you see on the photos is about 15 centimeters in width and 12,5 centimeters in height. It was printed on lowest quality with my Creality CR-200B which took about 10 hours altogether.
When you resize the STLs, make sure that the colored parts are about 0.8-1mm thick (z) so that they are not too thin, letting too much light through, and not too thick, blocking the light.
Feel free to remix it to make it better. I also added a back part with a small hole, in case you want to let out a wire to a socket.
When you resize the STLs, make sure that the colored parts are about 0.8-1mm thick (z) so that they are not too thin, letting too much light through, and not too thick, blocking the light.
Feel free to remix it to make it better. I also added a back part with a small hole, in case you want to let out a wire to a socket.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
