Thingiverse
Teensy++ 2.0 Case
von Red7s
11
Downloads
8
Likes
0
Makes
This is a case I made for the Teensy++ 2.0 board since I did not like the plain board floating around when it was in use.
You should be able to just print this, slide your teensy in and push the two sides together. When printing I used PLA at 215*c with my glass bed at 65*c
You should be able to just print this, slide your teensy in and push the two sides together. When printing I used PLA at 215*c with my glass bed at 65*c
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
