Tektronix PS280 Cal Test Binding Post Brackets

Purchased a Tektronix PS280 Power supply with 2 broken terminals for a steal. I was unable to find an exact replacement to replace these so I decided to modify it to use CAL Test posts.

These brackets fill the void left in the front of the equipment, and properly space out the posts to aid in soldering them in.

Due to the difference in size of the new posts, longer screws were needed to hold the output PCB onto the front. and some trial and error getting them to properly fit in with the components.

Notes:

Helpful tip, when soldering it in, have the rear of the post flush with the back of the PCB, this allows the posts to clear the components on the front of the board.

Some sanding/material removal will also have to be done on the top and bottom of the collar of each post to allow it to fit through the front.

Part Numbers:
Black: CT4231-NI-0
Red: CT4231-NI-2
Green: CT4231-NI-5