Thingiverse
Music
Vai al Modello
Telecaster Control Plate
6
Download
8
Likes
0
Makes
Was surprised there wasn't a telecaster control plate on here that was accurate.
I found one but the dimensions were quite off from US/MIM spec.
This is measured off my US Tele
There is a 1.5mm version and a 3mm version.
My factory one is 1.27mm but that was quite a bit too thin especially for 3D printing so I rounded up to 1.5mm.
The 3mm version is just there cause it's stronger in case you wanted it.
I found one but the dimensions were quite off from US/MIM spec.
This is measured off my US Tele
There is a 1.5mm version and a 3mm version.
My factory one is 1.27mm but that was quite a bit too thin especially for 3D printing so I rounded up to 1.5mm.
The 3mm version is just there cause it's stronger in case you wanted it.
JamesonLA pubblica anche su
3 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
