Thingiverse
Telecaster Pickguard
von Entropy85
260
Downloads
197
Likes
3
Makes
8 Hole Pickguard for Fender Telecaster w/neck pick up mounting holes.
This was so close to fitting on my MendelMax 1.5, but ultimately I had to split it up to be able to print it.
I'm still using my Prusa MK1 PCB heated bed, so if your bed is larger than that, you should be good with the full pickguard.
This was so close to fitting on my MendelMax 1.5, but ultimately I had to split it up to be able to print it.
I'm still using my Prusa MK1 PCB heated bed, so if your bed is larger than that, you should be good with the full pickguard.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!