Thingiverse
Telescope Accessory Dovetail Mount
von bowiesjustaknife
6
Downloads
10
Likes
0
Makes
This was modeled after the guidescope dovetail mount on my Celestron telescope. As far as I know, it is a standardized size.
Internal width goes from 34mm to 24mm at an angle of 60 degrees (internal height 8.7mm). External width is 42.5mm. The length is 40mm. The two mounting screws are M4, as is the clamp thumbscrew.
Either attach this to your OTA to hold a guidescope, or attach this to an accessory and mount on my upper OTA dovetail bar.
Internal width goes from 34mm to 24mm at an angle of 60 degrees (internal height 8.7mm). External width is 42.5mm. The length is 40mm. The two mounting screws are M4, as is the clamp thumbscrew.
Either attach this to your OTA to hold a guidescope, or attach this to an accessory and mount on my upper OTA dovetail bar.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
