Thingiverse
Telsa TUrbine Model
von Techmarine062
5
Downloads
5
Likes
0
Makes
Tesla turbine model that is mostly 3D Printed.
you will get get best results with a 0.4mm nozzle and 0.12 to 0.16 layer height.
model is sized for 626zz bearings or 6x19x6mm bearings
will need some polishing clean up but if cleaned up properly will spool up by blowing though the nozzle port. works best with compress air.
you will get get best results with a 0.4mm nozzle and 0.12 to 0.16 layer height.
model is sized for 626zz bearings or 6x19x6mm bearings
will need some polishing clean up but if cleaned up properly will spool up by blowing though the nozzle port. works best with compress air.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
