Temperature Tower - All Purpose

This is not a direct remix but a similar design to the Crua9 temperature test tower (https://www.thingiverse.com/thing:3347967).

Crua9's design has been my favorite thus far but I wanted free reign to choose my temperatures not dictated by the STL labeling, as well as have it 6 temperatures tall instead of 5.

Tests:
Stringing - Tested between the square and round pillars, and the spike.
Fine objects - Tested by the spike.
Print quality - Tested by the overhang and curved surface area.
Bridging - Short bridge is 15mm and the long bridge 30mm.

Slicer configuration:
The "base" piece is 2.5mm tall, print this at whatever temperature. Then, each temperature test zone progressing upward from there is 12.5mm tall. So, each desired temperature change should occur at 2.5mm, 15mm, 27.5mm, 40mm, 52.5mm, and 65mm.

Since this tower is free of any STL labeling you are free to configure this tower for any material and at any temperature gradient.

For PL