Tensegrity Rebel Table update

i added vertical tabs to attach the string. and i made small pegs for this.
NOTE - this peg is about 2.2 mm; the original hole i created is 3mm, but i scaled it to 80% when printing. so the peg needs to be custom size to your scaling.

the peg allows string/filament/fishline/etc to be put into the vertical holes top and bottom, and pegged in place, easier than tying, and you can make three pieces more exact in length.

NOTE, i did not make a peg for the center hole, i inadvertently did not calculate it when doing my pins. (easy enough to do if needed), but not too bad to attach and tie center sstring first, as the outer strings are the more finicky.

thanks to original designer !