Tension wire LED spot frame

Because of ordering time and the high price, I made a design for a very simple tension wire LED spot holder. Two printed parts and some basic hardware will do the job.

# Bill of Materials
* 4 bolts M5x20
* 2 M5 hexagonal stud connector nuts
* 1 bolt M4 x15
* 1 locknut M4
* 2 bolts m3x15 (with small or turned down head dia 4,6mm)
* 2 nuts M3
* 1 MR16/GU4 ceramic lamp holder with wires
* blank steel anodized wire 1,5 or 2 mm

##Putting it together
Remove careful the support from the M5 holes with an M5 drill. This support is added in the design.
With a drill and a saw or grinder you make a small slit in the connector nut. Width of the slit depends on the steel wire diameter. The depth is 50% of the length of the nut. Mount them according the pictures.
Mount the fitting with the m3 bolts. Carefully tighten the bolts not to crunch the ceramic material. You can put some blue on the thread to fix the nuts, or use locknuts.
Mount the clip with the M5 bold to the base. Use th