Tent Stake Holder

Edit: After tinkering with this design determined it was an all or nothing part. If you remove enough stakes the remaining stakes are no longer held by the holders. I generated a different version to address this. It can be found here: https://www.thingiverse.com/thing:4175129

Edit: Added OpenSCAD screenshots as the 3D render images aren't showing up. They may eventually but in the meantime this allows the 3D files to be viewed.

I have a set of 12 tent stakes that I wanted to organize. Cranked out a quick set of prints to organize and hold them. Stakes measured just under 7mm diameter. I laid out the pattern in LibreCAD and used OpenSCAD to linear extrude an upper (5mm) and lower (35mm) set of holders.
If you print this you may want to print the 5mm part first and check fit and then scale up or down as needed. I lucked out and the very first set I printed on my BigBox worked perfectly. They are just snug enough to not slip loose but you don't have to gorilla arm them to