Thingiverse
Tentacle Bolt Kit
door hoco
2
Downloads
1
Likes
0
Makes
This [Tentacle System](https://www.thingiverse.com/thing:6456655) kit includes a base and a grip that each attach using 4mm hardware.
The nut fits inside a slot and the bolt attaches to it through a hole in the bottom. The washer is optional. If you use a washer, it would go on the inside of the object behind attached, just under the bolt head.
Don't over-tighten the the bolt. Over-tightening can cause layers to separate and cause a crack by the nut.
You can learn all about the Tentacle System here: https://3ddoodle.com/tentacle-system/
The nut fits inside a slot and the bolt attaches to it through a hole in the bottom. The washer is optional. If you use a washer, it would go on the inside of the object behind attached, just under the bolt head.
Don't over-tighten the the bolt. Over-tightening can cause layers to separate and cause a crack by the nut.
You can learn all about the Tentacle System here: https://3ddoodle.com/tentacle-system/
hoco publiceert ook op
121 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
