Terminator HueForge (Thumbs Up)

Still learning Hueforge, there's a lot to it. I'm pretty happy with this one so figured I would go ahead and share it. Will probably come out with another similar once I get better at it! Thanks for looking, hope you enjoy! Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA Overture Red Transmission Distance: 4.8PLA Overture White Transmission Distance: 4.4This print uses 4 unique filaments Swap Instructions:Start with BlackAt layer #8 (0.72mm) swap to Blue GrayAt layer #13 (1.12mm) swap to RedAt layer #20 (1.68mm) swap to White for the rest. The frame used in this picture is a creation of my own, using very little filament and a super quick print. Will hang on wall or can stand up