Tesla 3 Card KeyChain

I received as a Christmas gift a Tesla 3 Key Card sheath with a key chain on it so that if I have to valet my car, I can give them the sheath with the card in it as opposed to just the card itself. I promptly lost this, however, I figured that I could build one and print it out. I found Gfretz's Tesla M3 Card Holder for the armrest area, which had all the appropriate dimensions and started with that. On Tinkercad, I doubled and inverted the holder, cut a hole in the middle so I could slide the card in and out easily, cut a hole in the end and put to very thin tabs at the top to make sure the card would not slide out easily. I added the chain holder and printed it in NinjaFlex with supports and a raft.

After I printed it I added a chain to the hole and it seems to work pretty well. There was some stringing that I had to shave off with a knife, but this will work to keep in my car for those times that I need to valet. I will post a finished picture in bright florescent Green (w