Tesla Charge Cable Holder

Fits North American Tesla charge connectors.

Designed to be printable without supports, both pieces should be printed with their backs flat against the build plate.

I printed the mounting rail with 100% infill to prevent cracking from any over-tight screws.

The mounting rail is designed for use with #6 screws, pan-head style (not countersunk)

The mounting rail is also designed so that it could be mounted with a 3M Command Strip instead of screws.

The fit between the rail and the cable holder was very snug on my printer; if it's too snug for you I might suggest a negative "horizontal expansion" value in Cura (or the equivalent setting in your slicer of choice) for the mounting rail piece