Tesla Gen 3 Wall Connector, Quick release bracket

NO SUPPORTS NEEDED! - Tapered the interference fit so no supports are required.Countersunk screws for wall half of bracket instead of recessed hole.4mm clearance from wall, prevents scratching when removing chargerOnly made screw holes solid with modifiers, not the interference edges as per Kole's original. I found that 4 perimeters with 20% infill is plenty strong.Hardware required:6G x 12mm Sheet metal tappers - file 1mm of sharp tip off, for mounting charger half of bracket. Link to Bunnings screws HERE8g 38mm - countersunk screws for wall half of bracket. Many sizes will fit, hole is M5. Link to Bunnings screws HEREPrint Settings:I printed on a Prusa MK3s+0.4mm nozzle0.3mm Layer height20% infillPETG for strength and heat resistance4 perimeters, 4 layers top and bottomAdded solid infill modifiers to screw holes for strength. See screenshot. You can load the 3mf file for a closer look.I increased the bed temp to 90 degrees. Mainly because this print takes up the whole bed and I d