Thingiverse
Tesla logo
von Nomad388
41
Downloads
34
Likes
0
Makes
Tesla logo, prints in separate pieces so you can stick them at your desired spacing, can make all one piece by request.
I used double sided sticky tape, some silicone based glue or a hot glue gun would work as well.
I used double sided sticky tape, some silicone based glue or a hot glue gun would work as well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
