Thingiverse
Automotive
Go to Model
Tesla Model 3 Jack Pad
243
Downloads
154
Likes
1
Makes
This is a Jackpad for jacking the Tesla Model 3.
You can insert the following O-RING: ID: 17.5mm, CS: 4mm in the groove to hold the pad on the car.
Print these in 100% infill ABS or NYLON and always use jack stands under the control arms. *Do not get under the car only supported by these jack pads!
You can insert the following O-RING: ID: 17.5mm, CS: 4mm in the groove to hold the pad on the car.
Print these in 100% infill ABS or NYLON and always use jack stands under the control arms. *Do not get under the car only supported by these jack pads!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
